How to Assemble the Motors for iDraw



  • motherboard
  • motor
  • rocker arm
  • screws
  • power charger


  1. Connect the motor wire to motherboard motor interface, pay attention to the position, the orange wire should be inside as follow
  2. Connect the power charger
  3. After powered on, the motor output axis will fix into one position, install the rocker arm, whose angle is up 45-60 degree
  4. Tighten the screws

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *